throwout bearing
Posted: Sun, 05/02/2010 - 6:55pm
Offline
User gallery (1)
throwout bearing
hey guys i bought a silvia clutch but the t/o bearing looks different, where can i get a gtir one? will any other cars t/o bearings work? thank you
__________________
13.2 @ 109mph w/ 2.2 60ft //////// garrett 60-1 @18psi, custom Weirtech header, fmic, 720cc injectors, 4" intake, mongoose exhaust, BC coilovers, AEM water/methanol kit, bully stage 4 clutch(highly recommended grips very hard yet engages like a stock clutch!!), and hoping to save up for a straight-cut gearset!!!! Ben
is there any numbers on the bearing? if i can remember correctly the bearing itself sits in a larger housing which make contact with the pressure plate fingers... which rotates on a radial bearing? you may be able to just switch these housings if the bearings match up...
if not you should be able to take the larger housing off and find a number on the bearing and go buy one at an industrial supplier... along side the dimension numbers the first 3 digits are a prefix denoting special treatments I.E. TS2 is high heat... usally this is the cheaper route when replacing bearings... all bearings conform to ISO standard... even Japanese ones :D
or you could just by an oem one.
Mine isn't bigger than yours.. I just like to drive
you can get it from the dealer, i bought one from courtesy nissan in texas, http://www.courtesyparts.com/listsearch.php?action=search&addtocart=1&products_id=329683&enquiry=30502-0W720 - the application is for a nissan axxes