rebulding motor
Posted: Mon, 06/14/2010 - 11:16pm
Offline
rebulding motor
hey guys im new on here and im just starting to rebuild a GTiR sr20det and im putting it into a FWD pulsar and im stuck on what fly wheel and what gear boxs to run (wanting to keep it front wheel drive) and what starter motor to use, any help would be appreshated thanks.
if you have a sr20 motor in your car, you can use the gearbox, starter, axles- get a clutch for the fwd sr20 and use the sr20 fwd flywheel, the flywheel holes needs redrilling to accommodate the larger pulsar flywheel bolts
I have nothing to contribute as I've never done that swap, other than to ask if you've checked out www.pulsar.org.au ?? Also, nissangtir.co.uk has a section for non turbo gtir's and sunny's. Have a look around those two sites, there should be plenty of information on them. Also have a look at www.sr20forum.com
RNN14
ive got some parts for sale in the selling section look in for gyir goodies i got bearings and arp bolts and studs. im nego
at the moment ive got all the 1600cc running gear in there i just need to know realy that if i run the gti gearboxs and flywheels what starter moter to use so the teeth line up correctly and also if it will fit into the block and bolt up properly. thanks
if your car has a 1600cc, you will need the the wire harness from the 2000cc gti. use the gti gearbox, flywheel,starter
you measn the GTiR loom? i wont have to change my front axles will i? from the 1600 to 1800? so the ti starter motor will def fit into the whole in the block and bolt up?
your setup is basically the same as as a b13 1.6 sentra. the axles in your car is different. basically you are changing your setup from a lx to a gti. you can use the gti loom or a gtir loom. the starter from the lx is different, you have to use the starter from the gti or a gtir
swt man thanks 4 that, got my head around it more