rear coolant hose

you are my hero. if i could kiss u i would

lol, no one should have a excuse now

was gonna do samco hoses this summer, you've just saved me about 100$.  too bad they don't make the 4 hose kit for the oil cooler and rear main water hoses

oh wait i just realized... they're all there my bad

pardon my numbnutness

you've pretty much saved everyone 150-200$

what are these exactly ?

$98.19+duty

just an fyi both samco kits would run you close to 300$

Why did I not do these while my trans was out :(

can you install these while the engine is in ?

you have to remove the intake manifold

OK so any tips on that? jeez it seems like a lot of difficult bolts to get...

The hoses ordered 5 days ago arrived today via dhl express flyer package, with an additional 10% to gov't at the door.
They're marked Autobahn88 and appear as above sealed in a'88 bag. The Autobahn88 part number is ASHK156; ZENRacing on eBay calls it ZEN040725. There's a lifetime warrantee card too: http://www.autobahn88.com/warranty/ along with small decal.
Pretty good deal for around $110 del. to the door, thanks for the info!

*** EVERYONE, if you change these, make sure to replace all the old OE clips by new once (the screw type at canadian tire are fine)... since the silicone hoses are a tiny bit smaller in exterior diameter, you will not get the coolant ones to hold down properly ... thus a big spill of coolant on your exhaust next time you run the car hard. I found this the hard way, just wanted to avoid you this unfortunate situation. Cheers, --McDave

Dave, sorry you had that trouble but thanks for the info!!!

I did this last time i had my engine out and they've worked fine. But alas the oil cooler hoses weren't included. I knew i should have replaced them but of course i didnt. I'm paying for it now though as one blew. I got the cooler and hoses out with the engine in place, which was quite the job considering i had to take the dreaded y-bracket off (it will get thrown in the trash now unless someone wants it(ha)). Needless to say im about 10 hours in and there is a hole in one hose and the other one is very spoungy so i'll replace them both. Very frustrating but i did end up having a little fun putting on my brand new state of the art exhaust tip. isn't it boss?!

someone tell me where the long straight one goes? I replaced mine last year, but couldn't find that one for the life of me lol

(insert sex joke here)

but seriously, there didn't seem to be anywhere to put it.

the long skinny one actually runs to the turbo. Is that actually oil, or is a water cooled turbo? I do not know.

http://www.ebay.ca/itm/NEW-ZPC-Nissan-Pulsar-GTIR-N14-Silicone-Heater-Hose-Kit-RNN14-SR20DET-USA-Ship-/200654140622?pt=Motors_Ca...

This looks like a completely different supplier than anyone else has used. They look like they're legit, I'm about ready to make the purchase so please post up if you have any info for me about ZPC.
Frank

I really hope that exhaust tip is a joke thats just sitting on there
........

Yes its a joke, its a plumbing drain pipe. I could probably sell it to the honda guys for a few bones though.

That's unfortunate. I cannot find a Samco or Autobahn88 hose set. If anyone has any leads or another good vendor, please let me know.

You will find those on ebay for sure ;)

Unfortunately, it's the ZPC that's showing up on eBay. I'll have to ask the ebay seller some pointed questions.

http://www.ebay.com/itm/Autobahn88-Silicone-Heater-Hose-Kit-Nissan-Pulsar-GTI-R-N14-RNN14-90-95-/290449327333?pt=Motors_Car_Truc...

gtir007,
Thank you. Autobahn88 hose kit purchased.
I still couldn't find it searching eBay, so thank you very much for posting the link for me.
Frank

If you havn't already changed out the radiator hoses and are thinking about upgrading the coolant hoses to silicone ones then here's a full kit with all the hoses.

http://www.ebay.com/itm/Silicone-Radiator-Coolant-Heater-Hose-Kit-Nissan-Pulsar-RNN14-GTi-R-N14-90-94-/120811694487?pt=Motors_Ca...

Wow, purchased Tuesday. Shipped from Hong Kong. Here today. I've had items take longer than that from within Ontario.
Major Props!

This brings a smile to the dial every time I see this pic.

Are they good enough for a fairly good build ? Or they really cheap compared to samco one's ?
Was really thinking about buying the kit

I like the look and feel of it, obviously I haven't used it in action yet, but I will be running the car in time attack this season so will know next fall if it can handle the heat!

These are as good as the samco and less than half of the price, AU$85 delivered to Canada

http://www.ebay.com.au/itm/Pulsar-GTiR-RNN14-silicone-heater-hose-kit-N14-red-/280824483818?pt=AU_Car_Parts_Accessories&hash=ite...